Chris,
The diagram on page 46 is for what is commonly referred to as the
"internal counter probe"
Yes, the Probe package contains other parts for constructing an RF Probe
(see page 9 of Appendix E for a schematic). There are no instructions
for constructing the RF Probe, but it is almost self explanatory. Yes,
the circuit traces for the RF Probe is built onto the back of the
"Switch Spacing Tool"
73,
Don W3FPR
On 2/20/2013 4:03 PM, Christophe F8ACF-56 wrote:
Good evening to all,
I asked a question about the RF probe, I have the diagram on page 46 with the ability to
" 10 pf" but there is another mounting tool spacing of buttons on the front
panel with a capacity, diode, a resistor, the same probe is?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
