Please reply direct, as I use digest mode and may not get the reply until later.
Hi All, I have a K2/10 and an Idiom Press CMOS4 keyer that I would like to use together. I have everything connected properly, the K2 set to "Hand" for the input device, and the the cables I made are properly fashioned and not shorted. HOWEVER, when I go to send (on either side of my paddles) the K2 goes into total key-down, and the only way to stop it is to turn the rig off OR disconnect the CMOS4. The CMOS4 doesn't seem to be malfunctioning. When I just have paddles connected to the K2, and use the internal keyer, everything works fine. Also, when I have the K2 set to "Hand" and the paddles connected, everything works fine. I am not sure if the problem is with the CMOS4, K2, or both. I know the CMOS4 works properly since I have been using it since 2008 on my ICOM with nary a problem. Any ideas/input would be appreciated. If the problem is in the CMOS4, I'll E-mail Rob at Idiom Press, but I figured that I would start here. Thanks & 73, David, KC9EHQ K1-4 sn 2051 K2/10 sn 7164 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
