David,
The mono plug will cause the problem you describe. Use a stereo plug
and leave the ring disconnected.
73,
Don W3FPR
On 2/25/2013 10:15 PM, David Dietrich wrote:
Hello Don,
I hope you are well. You are a huge help to all of us in the Elecraft
and QRP community.
Do you have the plug from the CMOS4 wired correctly?
I believe so. I bought a 3' cable with RCA Male plugs on both ends,
cut the cable in half, and then soldered an 1/8" mono to the cut ends.
I did make sure to wire the center wire to the tip of the mono plug
and the outer ground wire to the shell/lower shaft of the mono plug.
I am going to Ohm things out just to make sure.
My only other thought would be to use a stereo plug instead. If that
is the case, I might need to go to Radio Shack and get another cable
and some stereo connectors this time.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
