David,
Yes, it does seem to be a problem between C8 and the MCU input on the
Front Panel.
If you are getting good oscillation at the VFO (Q9 buffer) then check
continuity from C8 to the base of Front Panel Q1 - that should give you
a good check on the path continuity. Also check resistance to ground to
be certain there are no shorts.
The path from FP Q1 collector goes directly to the MCU pin 6, so check
continuity there too. Make certain that FP R11 and R12 are the correct
values.
The VFO frequency reading and the E42 error message have nothing to do
with U7, but after you solve the VFO counter problem, there may be
another problem lurking if you found no oscillation at U7 pins 6 and 7 -
hold that situation until later.
73,
Don W3FPR
On 3/4/2013 2:11 PM, David L DuPuy wrote:
K1 VFO PROBLEM: I’m building a K1, and have reached the mid-point on
populating the RF board, at the Alignment and Test, Part I (page 36). All
looks well until I get to VFO Range Test on p. 38, and I get E42 (VFO not
functioning). The previous resistance and voltage checks were all fine.
I have indeed looked carefully for wrong components or bad solder joints,
and all looks well. (I’m using a Weller WP-25 iron and have plenty of
experience with soldering, and re-checked very carefully with a quality
magnifying glass!)
I see a clean VFO signal on pin 1 of U7 (premix), and the same signal on
the emitter of Q9 (buffer). I see only hash on the side of C8 that goes to
P1 pins. The amplitude is only 0.07 volts... is it really supposed to be
that small??! The frequency is approximately 3030 (using analog
oscilloscope), which appears close to the 3090 minimum; I have not yet
gotten to the next page where the VFO range is adjusted.
On U7, pin 6 (to the crystal X1) I see a ragged, low amplitude signal which
appears to be the expected 15.00 MHz... but it sure is messy. I have
carefully checked continuity from U7 pin 6 to pin 9 on K1A on the filter
board, and that’s fine.
Can anyone tell me if this sounds like a problem upstream of Q8? Or maybe
a problem with U7? Many thanks... Sure am glad to find this Elecraft
reflector! David AC4BN
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
