Thanks Don, I guess not normally but I need to drive two separate devices -- the ant switch with the tribander and a 6 band bandpass filter. 10-15-20 can be wired together to drive the ant switch but need to be separate for the bandpass filter. Cheers, Fred
-----Original Message----- From: Don Wilhelm [mailto:[email protected]] Sent: Friday, March 08, 2013 2:06 PM To: Cady, Fred Cc: [email protected] Subject: Re: [Elecraft] RC2 - high side and low side different Fred, With the KRC2, no diodes are needed, just connect them together. 73, Don W3FPR On 3/8/2013 3:47 PM, Cady, Fred wrote: > Thanks Don. With diodes that will work great. > 73 > Fred > > > -----Original Message----- > From: Don Wilhelm [mailto:[email protected]] > Sent: Fri 3/8/2013 11:08 AM > To: Cady, Fred > Cc: [email protected] > Subject: Re: [Elecraft] RC2 - high side and low side different > > Fred, > > You can wire "OR" either the high side or the low side. > If you are running the tribander on the low side, just connect the 10, > 15, and 20 outputs together, and drive the bandpass filter from the > separated low side outputs. Swap 'high' and 'low' if required. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
