It's a MC-60 and the switch is "Out".
On Mar 14, 2013, at 4:36 PM, Joe Subich, W4TV wrote: > > Was it an MC-60 or an MC-60A? The MC-60 is a straight dynamic > mic while the MC-60A included a preamplifier circuit in the base. > > 1) make sure your K2 is not set up with bias (no 5.6K resistor > on the P1). > 2) make sure the preamplifier is *bypassed* (switch "OUT") in the > base of the MC-60A. > > Finally, make sure the cable is wired for Kenwood and has not been > rewired for some other transceiver. The MC-60/60A was a good mic > and has been used with a lot of other transceivers by replacing > the cable from the base to the rig with one wired appropriately. > > 73, > > ... Joe, W4TV > > > On 3/14/2013 3:35 PM, Stephen Roberts wrote: >> I was recently given an MC-60 mic and I read that the MC-60 was perfectly >> compatible with the K2, but I plugged it in and it doesn't work, so what >> should I check for? >> >> 73 >> Steve >> W1SFR >> >> >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
