My MC-60 mic says on the bottom by the switch 'mic amp' in/out. There isn't an 'A' on the Kenwood trim on the front - just MC-60. Although it may be an MC-60A, there is no visible designation as such.
- 73 de Mike, K6MKF, W6NAG, NCDXC, Conway Reef 2012, K3-P3 Addict, Maui -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Don Wilhelm Sent: Thursday, March 14, 2013 4:12 PM To: [email protected] Subject: Re: [Elecraft] Kenwood Mc-60 mic with K2 The MC-60 (not A) schematic that I see on the G4WPW website indicates that the switch changes from low impedance to high impedance. For use with the K3 and other modern transceivers the switch should be in the low impedance position. From the schematic, I cannot understand an "out" label on the switch. If you have an MC-60A, then "out" would be reasonable referring to the preamp either in or out. 73, Don W3FPR On 3/14/2013 6:53 PM, Stephen Roberts wrote: > It's a MC-60 and the switch is "Out". > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
