Arie, Changing the filter width in the Main RX does not change the filter width in the SUB RX.
To change the filter width in the SUB RX you must HOLD the B SET button. You will see B SET displayed in the display. Using the same method as with the MAIN RX adjust the width and then HOLD the B SET button again and you will have the SUB RX Filter that you want. When working split with the K3, I usually set the SUB RX filter a little wider than the MAIN RX filter, so I can hear more band width in a pile up 73, Tom Amateur Radio Operator N5GE ARRL Lifetime Member QCWA Lifetime Member On Sat, 23 Mar 2013 10:45:54 +0100, Arie Kleingeld PA3A <[email protected]> wrote: >SubRX filtering will also track the mainRX filters if diversity is >switched on. > >73 >Arie PA3A > >Op 22-3-2013 22:25, Bill W4RM schreef: >> I.E. if I >> go to CW and select the FL4 400 HZ filter on the main receiver the SUB >> receiver doesn't sound like the filter is selected. Same case in SSB with >> 1.8khz filter. >> >> > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
