Christophe,
The voltage that you see in the display will always be lower than the
voltage at the input power jack.
There is a reverse polarity protection diode in the K2 and there is a
slight voltage drop across the fuse.
That will make the voltage inside the K2 0.4 to 0.5 volts lower than the
voltage of your power source.
73,
Don W3FPR
On 3/25/2013 8:28 AM, Christophe F8ACF-56 wrote:
hello all,
Part 2 and alignment validated everything is OK, BFO = 5.9 kHz, VCO of 2.17 V
to 6.0 V, 13 KHz PLL so it's OK
Song minor or I do not see how pressing the button "display" was the voltage
and amperage, the amperage is only Ok, there is a gap between the multimeter reading and
that of K2, I not know the origin or the setting of this part
for those that want to place or is the video test::
http://dl.free.fr/tS9ocrCFC
thank you for your help
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
