On 4/24/13 at 2:20 PM, [email protected] (ab2tc) wrote:
I have recently converted more or less completely to Anderson Power Poles
for all my power supply needs. ... For the big stuff, radios
with #12 power wires I am not worried
about the lack of strain relief on the connectors. But for the flimsy power
cables supplied with accessories like my KAT500, LP-100A, Lantronix serial
servers I am. Has anybody found a good solution for this? Should I just fill
the back of the connectors with epoxy or is there a better way?
I haven't worried about the lack of strain relief, but with the
small wires I have had to solder the wires to the metal
connector inserts after crimping to keep them from pulling loose.
Cheers - Bill, AE6JV
-----------------------------------------------------------------------
Bill Frantz | I don't have high-speed | Periwinkle
(408)356-8506 | internet. I have DSL. | 16345
Englewood Ave
www.pwpconsult.com | | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
