How is the CW sidetone handled? Does the K3/0 generate it locally or is it somehow transferred to the remote K3? It doesn't take much of a lag to make CW difficult to send unless the audio response is immediate.
Thanks Jim On Sun, May 19, 2013 at 4:37 PM, iain macdonnell - N6ML <[email protected]>wrote: > Hi Eric, > > Agreed. My point was that it's the RemoteRig boxes that are doing the > power on/off, not the K3/0. The control RRC senses when the K3/0 is > powered on, and tells the radio RRC to send the power-on signal to the > remote K3. Since RemoteRig is not the only way to to utilise a K3/0 > (although it may be the most common), it would be misrepresentative to > state that at the K3/0 (itself) is capable of powering on/off a remote > K3. > > 73, > > ~iain / N6ML > > > On Sun, May 19, 2013 at 1:32 PM, Eric Swartz WA6HHQ - Elecraft > <[email protected]> wrote: > > The K3/0 via the RemoteRig boxes absolutely -can- power up and down the > remote K3. It uses a pin on the K3 AuxPort that acts the same as pressing > the power button on the K3. > > > > Powering up the K3/0 powers up the remote K3. And powering off the K3/0 > powers off the remote K3. Also, if you lose the internet link, the remote > K3 will gracefully power down. > > > > 73, > > > > Eric > > elecraft.com > > _..._ > > > > > > > > On May 19, 2013, at 12:42 PM, iain macdonnell - N6ML <[email protected]> > wrote: > > > >> I'm fairly sure that the K3/0 will NOT power off a remote K3. It > >> certainly won't power it on. However if you use it in conjunction with > >> a RemoteRig setup, that WILL handle power on/off of the remote K3. > >> > >> 73, > >> > >> ~iain / N6ML > >> > >> > >> On Sun, May 19, 2013 at 5:08 AM, D Joyce <[email protected]> wrote: > >>> GM Brian: > >>> > >>> The K3/10 I'm using and my friends K3/0 both used at control sites > turn the > >>> power On & Off to the K3/100 used at the radio site, so I expect that > the > >>> new "mini" K3/0 would as well. Suggest that you use an internet > controlled > >>> switch to turn on the AC to the 12 V power supply and then the "Power" > >>> switch on the K3/0 will turn on and link to the K3/100. It all works > very > >>> well. > >>> > >>> 73, Doug VE3MV > >>> > >>> > >>> ----- Original Message ----- From: "Brian F. Wruble" < > [email protected]> > >>> To: "Elecraft Reflector" <[email protected]> > >>> Sent: Sunday, May 19, 2013 7:41 AM > >>> Subject: [Elecraft] K3/0 Question > >>> > >>> > >>> > >>>> I was planning to use my K3, currently being built, remotely. I note > in > >>>> the > >>>> operator's manual that you are advised not to interrupt power to the > rig, > >>>> but to always use the power button to turn it on and off.. > >>>> > >>>> That kind of kills my plans for remotely powering up and down using an > >>>> internet controlled switch. > >>>> > >>>> My question is: > >>>> > >>>> *Does the K3/0 handle power on/off for the K3?* > >>>> * > >>>> * > >>>> Tnx. 73 de Brian W3BW > >>>> > >>>> > >>>> *Brian F. Wruble, C.F.A. > >>>> > >>>> *70 is the new 40.* > >>>> * > >>>> Mail: 1107 Key Plaza, PMB 447 Key West, FL 33040-4077 > >>>> Summers: P.O.Box 57, 7400 Augustine Herman Highway, Georgetown, MD > 21930 > >>>> eFax 305.768.0278 > >>>> ______________________________________________________________ > >>>> Elecraft mailing list > >>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft > >>>> Help: http://mailman.qth.net/mmfaq.htm > >>>> Post: mailto:[email protected] > >>>> > >>>> This list hosted by: http://www.qsl.net > >>>> Please help support this email list: http://www.qsl.net/donate.html > >>> > >>> ______________________________________________________________ > >>> Elecraft mailing list > >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft > >>> Help: http://mailman.qth.net/mmfaq.htm > >>> Post: mailto:[email protected] > >>> > >>> This list hosted by: http://www.qsl.net > >>> Please help support this email list: http://www.qsl.net/donate.html > >> ______________________________________________________________ > >> Elecraft mailing list > >> Home: http://mailman.qth.net/mailman/listinfo/elecraft > >> Help: http://mailman.qth.net/mmfaq.htm > >> Post: mailto:[email protected] > >> > >> This list hosted by: http://www.qsl.net > >> Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
