OK, I will head in this direction. I am using the USB to 232 cable from Elecraft, and it was working fine at 4800.
I will report results. Thanks for your help. Brian *Brian F. Wruble, C.F.A. *70 is the new 40.* * Mail: 1107 Key Plaza, PMB 447 Key West, FL 33040-4077 Summers: P.O.Box 57, 7400 Augustine Herman Highway, Georgetown, MD 21930 eFax 305.768.0278 On Sat, May 25, 2013 at 7:00 PM, Ed <edw...@sisqtel.net> wrote: > What Don is saying is true. My manual, page 58 shows the factory default > as 4800 b. Try resetting it to 38400 using the “config” menu. > You will have to also do the same with your computer. Then try reloading > the software. Anything you have saved with your present setup > could be corrupted so you may have to start over. 38400 is what the K3 > and it’s companions want to communicate with. Also not > all RS232 to USB cables will work. A lot of them have something missing > in the chip they use. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html