Brian There are two other things you can check. On the K3, when pressing the “Xmit” button, the one above the volume control, does the red “Xmit” LED light? It is located above the “Phones” jack. If not look over on the extreme right of the display. There is an arrow that indicates which VFO you are transmitting on. Just below, or above, the arrow will be “TX”. If TX is steady in it’s state you should be seeing power out and the Xmit LED should light. If the “TX” is flashing, this indicates that the K3 is in “Test Mode”. Test mode will inhibit Xmit and the red LED will not light. This function is toggled pressing and holding the grey “Mode” button.
If nothing here helps I suggest calling Elecraft for help. They will treat you very well. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html