On page 48 of the K2 manual the S-meter alignment is done. I was able to get
the Cal S low done just fine. When I then moved on to the Cal S HI ( with the
RF gain fully counter clockwise) I was not able go get any segments of the S
meter to light up. I adjusted the VFO full circle and not one segment of the S
meter would light up. The AGC voltage was adjust to 3.80 volts DC without any
problem. Also I read on the list of a similar problem and Don suggested to
check RP6 pin's 9 and 10 and U6 pin 3 (all on the control board) I reheated and
soldered these, actually all the pins on U6 and RP6 and this did not solve the
problem. Just wondering what the next step would be?MikeVE3WDM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
