I am slightly confused on the proper operation of the PR6. I installed the PR6
on my K3 according to the instructions:
** CTRL line used (supplied DB-15 connected to ACC port)
** PR6 jumper P2 removed
** CONFIG: DIGOUT1 ON set on 6m
So, when I am operating on 6m do I select RX ANT and PRE or just RX ANT? If
just RX ANT is the appropriate protocol what will be the effect will selecting
both PRE and RX ANT? I've fuddled about with these buttons but would like to
know the recommended procedure.
73
Bill
William Hein, AA7XT
ex-AA4XT, NT1Y, AA6TT, KC6EDP
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
