Bill, I have the PR-6 on my K3. Generally I leave the PRE on all the time
unless
it is necessary to drop it out due to very strong signals on the lower
frequency
bands. The only control I use is the RX ANT to switch the PR-6 in and out
with
the configuration you have on your set up. It is effective and is almost
always
on when I am on 6 meters with the K3. Enjoy your K3 on 6 as things are now
popping on the band. 73
K0AZ
Mike Sanders
EM37cd SW Missouri
www.k0az.com
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of William Hein
Sent: Thursday, May 30, 2013 10:17 AM
To: [email protected]
Subject: [Elecraft] using the PR6
I am slightly confused on the proper operation of the PR6. I installed the
PR6 on my K3 according to the instructions:
** CTRL line used (supplied DB-15 connected to ACC port)
** PR6 jumper P2 removed
** CONFIG: DIGOUT1 ON set on 6m
So, when I am operating on 6m do I select RX ANT and PRE or just RX ANT? If
just RX ANT is the appropriate protocol what will be the effect will
selecting both PRE and RX ANT? I've fuddled about with these buttons but
would like to know the recommended procedure.
73
Bill
William Hein, AA7XT
ex-AA4XT, NT1Y, AA6TT, KC6EDP
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
