I seem to recall having a similar problem with FLDIGI. I think there is
a checkbox to always use USB that I had to check to get the frequency to
display correctly using DATA-A mode.
Mike
KI0HA
On 5/30/2013 5:27 PM, Brendon Whateley wrote:
When I use Data-A on the KX3, FLDIGI shows the incorrect operating frequency
and I don't know how to fix that. The frequency is correct when I use the side
band.
- Brendon
KK6AYI
On May 30, 2013, at 2:53 PM, Greg wrote:
And always best to use Data-A for data modes via soundcard (or AFSK-A
for RTTY). This will help with a clean signal by keeping compression
turned off to avoid over-driving the audio chain.
73
Greg
On 5/30/13, David Sanders W4DES <[email protected]> wrote:
I'm using the SignaLink USB. SignaLink sells various cables to hook up to
different radios. You need to get the cable part no. SLCABK3. It plugs
into the line input, line output and PTT input jacks on the back of the K3.
In addition, you will reconfigure some jumper wires inside the SignaLink
USB. Instructions come with the cable.
73,
David Sanders W4DES
K3 (7409)
On May 30, 2013, at 5:37 PM, Richard W Hemingway <[email protected]>
wrote:
Hi,
I think that I may have messed up and it got away from me. What I was
asking is whether any of you are using SignaLink USB. Where do the cables
plug in on the back of the K3. Do you have to turn on Data or can you use
SSB? I have written to SignaLink but have not received an answer. I know
that you don't have to use SL for PSK, and I may not go that way, but I
have it for the rig I just sold and Would like to use it if I can.
Dick, N5XRD
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
