Last night while doing a final visual inspection of the RF board, I noticed that I somehow managed to scrape a bare spot in the insulation of one of the bifilar windings of T3. It is not in any danger of shorting, but this rig is going on a boat and that little bit of bare copper is going to be green and fuzzy in no time unless I either replace it or patch up the insulation. It is where the winding makes the last turn around the toroid on it's way to the PC board. Is there anything I can use like fingernail polish that will do the job without adversely affecting the part, or is it re-wind time? Thanks
73, N7NSD Norm _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
