Norm, While the 'fingernail polish' trick may work just fine, I would believe that simply rewinding T3 would be just as easy and you would end up with something you need not worry about if some 'funny' symptoms should develop later on (do it right, you wil not be sorry).
73, Don W3FPR > -----Original Message----- > > Last night while doing a final visual inspection of the RF board, > I noticed that I somehow managed to scrape a bare spot in the > insulation of one of the bifilar windings of T3. It is not in > any danger of shorting, but this rig is going on a boat and that > little bit of bare copper is going to be green and fuzzy in no > time unless I either replace it or patch up the insulation. It > is where the winding makes the last turn around the toroid on > it's way to the PC board. Is there anything I can use like > fingernail polish that will do the job without adversely > affecting the part, or is it re-wind time? Thanks > > 73, > N7NSD > Norm > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
