Bill,
Go into the K1 menu and change the "b2" menu parameter from 14 to 10.
If the 4 band board has the 18.1 kHz crystal at X3, tap DISPLAY to
change the parameter from 10.0 to 10.1.
73,
Don W3FPR
On 6/17/2013 3:27 PM, William LeComte wrote:
I purchased a used pre-built K1 from a friend with a known issue in the 4
band module. My 4 band module covers 40, 30, 20, and 15 meters but 30
meters does not function. What I observed is when the Band switch is used
to cycle through the bands 30 meters does not show up in the display, but
20 meters appears to show up twice. One of the appearances of 20 meters
functions, but the other does not, which is likely 30 meters not being
recognized and showing up as 20 meters. Any suggestions as to what would
cause 30 meters to not be recognized?
Bill
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
