Thanks Don, I'll try that. 73,
Bill KB1DX On Mon, Jun 17, 2013 at 4:24 PM, Don Wilhelm <[email protected]> wrote: > Bill, > > Go into the K1 menu and change the "b2" menu parameter from 14 to 10. If > the 4 band board has the 18.1 kHz crystal at X3, tap DISPLAY to change the > parameter from 10.0 to 10.1. > > 73, > Don W3FPR > > > On 6/17/2013 3:27 PM, William LeComte wrote: > >> I purchased a used pre-built K1 from a friend with a known issue in the 4 >> band module. My 4 band module covers 40, 30, 20, and 15 meters but 30 >> meters does not function. What I observed is when the Band switch is used >> to cycle through the bands 30 meters does not show up in the display, but >> 20 meters appears to show up twice. One of the appearances of 20 meters >> functions, but the other does not, which is likely 30 meters not being >> recognized and showing up as 20 meters. Any suggestions as to what would >> cause 30 meters to not be recognized? >> >> Bill >> ______________________________**______________________________**__ >> Elecraft mailing list >> Home: >> http://mailman.qth.net/**mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft> >> Help: http://mailman.qth.net/mmfaq.**htm<http://mailman.qth.net/mmfaq.htm> >> Post: mailto:[email protected].**net <[email protected]> >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
