Thanks for all replies both on and off list. I will take a look tomorrow and see if I can improve it.
-- 73 de G8DX/A On 24 Jun 2013, at 13:42, Don Wilhelm <[email protected]> wrote: > Jack, > > The most common cause for that condition is that the connector blades have > not been inserted into the APP body far enough. > Look at the end of the connector assembly - if you can see the tip of the > spring finger under the contact blade, then the blade has not been fully > seated - give it a push with a small screwdriver and it should snap into > place. > > A properly constructed APP connector takes about 10 pounds of force to remove > it. > > 73, > Don W3FPR > > On 6/24/2013 8:26 AM, G8DX wrote: >> Hi >> >> Just finished building the basic K3 (sub rx and 100w PA awaiting >> installation). >> >> Total build time was about 10 leisurely hours spread over a week. Throughout >> the entire build I have only found one small issue which I find remarkable! >> Hats off to Elecraft. >> >> Anyway, my issue is the Anderson power connector doesn't firmly latch onto >> the connector on the rig. It fits on and powers the rig but pulls off very >> easily. Have I installed it incorrectly maybe? > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
