Bruce,
The KAT100 cable does not use the RXD, TXD and Signal Ground RS-232
signal lines, so unless your cable has a fault (a short between
conductors at the K2 end) the KAT100 connection is not to blame.
Both the TXD and RXD signals are used when attempting the Hyperterminal
Test 1, so I would figure that the KPA100 RS-232 communications is working.
Make certain that the COM port is set to 4800 baud. Try another
computer if possible.
73,
Don W3FPR
On 7/13/2013 7:28 PM, K1FFX wrote:
Followup with some additional info: I inserted a breakout box (yes ... I
still have one!) to verify that my cable is OK ... and it is. The PC's TXD
signal (pin 2) is showing up on the K2 end of the cable. One other piece of
info: the cable is actually a Y-cable ... I built the KAT100 this past March
and it is on-line.
Thanks -
Bruce K1FFX
-----
Bruce Rosen
K1FFX
K2/100 6982 KSB2 KAT100-1
--
View this message in context:
http://elecraft.365791.n2.nabble.com/K2-N1MM-Logger-with-KPA100-tp7576690p7576695.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
