What am I thinking!! Or, writing... I meant to say P3, not KX3. Same question but applied to P3. Yes, my KX3 looks correct.
peh On Aug 9, 2013, at 12:03 PM, David Fleming <[email protected]> wrote: > Hi Phil, > > There is only one other firmware revision number on the Firmware page ( DSP ) > in the KX3 Utility. It should display the DSP firmware revision installed in > the KX3. If it is displaying "N/A" in the DSP installed field, there could be > a serial communication problem. Does it always display "N/A"? Try clicking > the "Check Revisions Now" button and see if that helps. Try setting the KX3 > RS232 speed to 38400 if it is not already. > > David, W4SMT > > From: Phil Hystad <[email protected]> > To: "[email protected] Reflector" <[email protected]> > Sent: Friday, August 9, 2013 1:34 PM > Subject: [Elecraft] KX3 Utility Firmware load status question > > On the KX3 utility program (I use the Mac version) the Firmware page shows > the version numbers of the firmware loaded on the KX3 as well as the firmware > available for the KX3 (the two columns). But, for the loaded firmware, only > the version number for MCU is shown, the other version numbers are indicated > N/A. Now, for each of these N/A entries, there is a corresponding entry in > the "available" (next column to right) with the actual version number. > > Why does the KX3 not show the version number loaded (installed) on the KX3 > for these others (other than MCU)? > > Similarly, I have noticed this on other utility programs too and I am not > sure why some say N/A and others give the version number. > > 73, phil, K7PEH > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
