OK, that is probably the answer. I do not have the P3SVGA. Thanks, 73, phil, K7PEH
On Aug 9, 2013, at 1:16 PM, David Fleming <[email protected]> wrote: > Do you have the P3SVGA Adapter installed in the P3? If not, the SVGA (and all > of the FPGA) installed fields will show "N/A". If you do have the P3SVGA > installed and are seeing "N/A" in the SVGA and FPGA installed fields, check > that the P3SVGA is enabled in the SVGA Menu. > > David > > From: Phil Hystad <[email protected]> > To: David Fleming <[email protected]> > Cc: "[email protected] Reflector" <[email protected]> > Sent: Friday, August 9, 2013 3:46 PM > Subject: Re: [Elecraft] KX3 Utility Firmware load status question > > What am I thinking!! Or, writing... > > I meant to say P3, not KX3. Same question but applied to P3. Yes, my KX3 > looks correct. > > peh > > > On Aug 9, 2013, at 12:03 PM, David Fleming <[email protected]> wrote: > >> Hi Phil, >> >> There is only one other firmware revision number on the Firmware page ( DSP >> ) in the KX3 Utility. It should display the DSP firmware revision installed >> in the KX3. If it is displaying "N/A" in the DSP installed field, there >> could be a serial communication problem. Does it always display "N/A"? Try >> clicking the "Check Revisions Now" button and see if that helps. Try setting >> the KX3 RS232 speed to 38400 if it is not already. >> >> David, W4SMT >> >> From: Phil Hystad <[email protected]> >> To: "[email protected] Reflector" <[email protected]> >> Sent: Friday, August 9, 2013 1:34 PM >> Subject: [Elecraft] KX3 Utility Firmware load status question >> >> On the KX3 utility program (I use the Mac version) the Firmware page shows >> the version numbers of the firmware loaded on the KX3 as well as the >> firmware available for the KX3 (the two columns). But, for the loaded >> firmware, only the version number for MCU is shown, the other version >> numbers are indicated N/A. Now, for each of these N/A entries, there is a >> corresponding entry in the "available" (next column to right) with the >> actual version number. >> >> Why does the KX3 not show the version number loaded (installed) on the KX3 >> for these others (other than MCU)? >> >> Similarly, I have noticed this on other utility programs too and I am not >> sure why some say N/A and others give the version number. >> >> 73, phil, K7PEH >> >> > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
