I am having a configuration issue that I have spent hours trying to figure out and need some help please.
As a CW person, I seldom operate SSB and I am trying to get set up for this weekend's CQWW SSB test. Below are some of my configuration for my K3 and the attached are jpg configuration sheets from K3 EZ. In any band in the SSB portion, I have no audio output any time I am in the USB or LSB mode, however if I change from USB to CW, I have normal audio but of course I can't copy the SSB signals. This is true whether I have my SUB turned on or not. I have my CM-500 headset plugged into the rear of my K3 and I have the RS20S headset plugged into the front panel PHONES jack and I have no audio with either or both of the headsets plugged in. With both headsets removed, I have no speaker audio in the SSB mode, but normal audio in the CW or AM mode. Any helpful suggestions would be greatly appreciated! In CONFIG I have: SPKRS = 1 SPKR+PH = YES L-MIX-R = A b Thanks for your input and 73, Tom - W4BQF PS: I have been trying to configuration pictures from K3-EZ but nothing is getting onto the reflector. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
