In addition to the display problem on 30 meters described in a previous
post, I have never been able to use the KPA 500 on 80 meters. If I run
the K3 at 100 watts, the swr shows very low (below 1.3:1) and is
consistent. If I put the KPA500 in line, it faults with "high swr" as
low as 75 watts displayed on the KPA's display. Also,the swr changes as
I transmit, randomly spiking up to full scale and shutting the amp down.
It does this with even more frequency at higher power. I have eliminated
as many other variables as possible and have come to the conclusion that
on 80 meters (only....apparently) enough rf makes its way into the
KPA500 to cause this behavior (even at very low power). The antenna is a
shunt fed tower, fed with buried hard line about 100 feet from the
shack. I feed the same tower (same feedline) on 160 without issue.
My instincts tell me the ingress point is the AUX cable (the one thing I
haven't tested), but I am otherwise at wit's end. Anyone have any
suggestions?
Bob
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
