Check to be certain both channels are being sent to the soundcard. The
levels should be the same in both channels. It could be a cable problem
or a soundcard problem that is only presenting one channel to the NaP3
application. Unplug each channel (one at a time) and see if the display
indicates about the same level from each channel (yes, you will have
mirrored images with only one channel).
Do you have the KX3 set to output RX IQ signals?
If all that is OK, then tune to a strong signal (S-9 plus) and the NaP3
WBIR algorithm should eliminate the mirrored responses.
73,
Don W3FPR
On 12/29/2013 7:54 PM, Reed Bumgarner wrote:
I'm having problems setting up NAP3 with the KX3 and a Creative XI-FI
soundcard plugged into my ASUS W 8.1 laptop. I followed the configure
instructions as closely as I could but the display is not right. It's just
a symmetrical waterfall and spectrum around the center of the screen. I.E.
One side is a mirror image of the other. Otherwise it recognizes the rig
and soundcard fine. Any ideas?
Reed AA1RB
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
