Found the problem thanks to your suggestions. After a bit of digging discovered that the X-Fi Go Pro has no stereo mixer. Switched to the slightly more expensive and much bulkier X-Fi Surround and now works well. Thanks all. Reed AA1RB
On Sun, Dec 29, 2013 at 10:43 PM, Don Wilhelm <[email protected]> wrote: > Check to be certain both channels are being sent to the soundcard. The > levels should be the same in both channels. It could be a cable problem or > a soundcard problem that is only presenting one channel to the NaP3 > application. Unplug each channel (one at a time) and see if the display > indicates about the same level from each channel (yes, you will have > mirrored images with only one channel). > Do you have the KX3 set to output RX IQ signals? > > If all that is OK, then tune to a strong signal (S-9 plus) and the NaP3 > WBIR algorithm should eliminate the mirrored responses. > > 73, > Don W3FPR > > > On 12/29/2013 7:54 PM, Reed Bumgarner wrote: > >> I'm having problems setting up NAP3 with the KX3 and a Creative XI-FI >> soundcard plugged into my ASUS W 8.1 laptop. I followed the configure >> instructions as closely as I could but the display is not right. It's >> just >> a symmetrical waterfall and spectrum around the center of the screen. >> I.E. >> One side is a mirror image of the other. Otherwise it recognizes the rig >> and soundcard fine. Any ideas? >> Reed AA1RB >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
