Mike,
It sounds like a bad solder connection somewhere.
Before you dig into the K3, try the mic directly on the K3. If all is
OK, then investigate the connector for the Duo to K3 cable.
If it persists with the mic connected directly to the K3, then it may be
a K3 problem.
Right now, there are too many variables - the Duo to K3 cable, the PR781
mic connector, the DUO itself, and the K3 - all can be suspect.
Eliminating the Duo will reduce the variables to 2 - the PR781 mic plug
and/or the K3.
73,
Don W3FPR
On 1/29/2014 12:58 PM, Mike Sanders wrote:
Greetings All, My K3/10F now K3/100 plus mostly loaded has a problem.
The mic connector has to be pressed down a bit to get PTT when using
the K3 on SSB. I use a Heil PR781 mic that goes through a Rigblaster Duo.
The connector to the K3 comes from the Duo and is never changed or
fooled with. Before I pull the front panel module has anyone had this
same issue and what was the problem? Thanks for any hints/help. 73
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
