I think the k3 Utility will match whatever the K3 is set to. AFAIR, it cycles thru all the baud rates.
73, Mike NF4L On Feb 4, 2014, at 4:19 PM, Sam Morgan <k5oai....@gmail.com> wrote: > check the utility baud rate is set correctly to match the k3's baud rate > CONFIG RS232 > > On 2/4/2014 3:06 PM, Carl Yaffey wrote: >> I installed the utility and installed what I think is the driver via CDM >> c2.08.30 WHQL Certified.exe >> I connected the KUSB cable to the K3’s RS232 port. I started the utility and >> selected COM3 as it was the only choice. >> The utility cannot find the K3. >> What am I missing? >> >> Carl Yaffey K8NU >> Banjo, guitar, bass, mandolin, dobro. >> recording studio. >> cyaffeyno_s...@gmail.com >> 614 268 6353, Columbus OH >> http://www.carl-yaffey.com >> http://www.grassahol.com > > -- > GB & 73 > K5OAI > Sam Morgan > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html