you are quite correct,
just goes to show I am playing with to many different pieces of software
that aren't as smart as elecraft's utils <g>
On 2/4/2014 3:25 PM, Mike Reublin wrote:
I think the k3 Utility will match whatever the K3 is set to. AFAIR, it cycles
thru all the baud rates.
73, Mike NF4L
On Feb 4, 2014, at 4:19 PM, Sam Morgan <k5oai....@gmail.com> wrote:
check the utility baud rate is set correctly to match the k3's baud rate
CONFIG RS232
On 2/4/2014 3:06 PM, Carl Yaffey wrote:
I installed the utility and installed what I think is the driver via CDM
c2.08.30 WHQL Certified.exe
I connected the KUSB cable to the K3’s RS232 port. I started the utility and
selected COM3 as it was the only choice.
The utility cannot find the K3.
What am I missing?
Carl Yaffey K8NU
--
GB & 73
K5OAI
Sam Morgan
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
