Indeed Don, that change has helped a lot. Now I can tune the
vast majority of SSB signals on 160, 80, 20, 15, and 10 meters
while in coarse mode.
I have noticed that some of my tuning problems seem to be slow
response from the K3 - P3 - SVGA link. I usually tune SSB
looking at the waterfall on the SVGA screen. There is a bit of
lag updating the vertical stripe showing bandwidth and the tuned
frequency at the top middle of the screen. My hand gets ahead of
the screen. I think this problem would go away if I looked at
the K3 display, but then I can't see where the signal is.
Cheers - Bill, AE6JV
On 2/3/14 at 1:36 PM, [email protected] (Don Wilhelm) wrote:
One thing you might want to check is your menu setting for VFO
CRS (VFO Coarse Tuning). You could set that to 500 Hz for SSB
- it is a per mode setting.
That may not help with your request about the SPOT button, but it may be a good
substitute.
On 2/2/2014 4:30 PM, Bill Frantz wrote:
A small item for the infinitely long desired feature list:
I have noticed that SSB stations usually transmit on multiples of 500
Hz -- For example the Elecraft SSB net 14.3035 MHz and and W1AW/5 on
28.4570 MHz. If pressing SPOT when in SSB mode would set the frequency
to the nearest multiple of 500 Hz it would quite useful.
-----------------------------------------------------------------------
Bill Frantz | gets() remains as a monument | Periwinkle
(408)356-8506 | to C's continuing support of | 16345
Englewood Ave
www.pwpconsult.com | buffer overruns. | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
