Now before you guys think I too am complaining--no, I just have a curious mind!
Two questions that I am sure you more experienced can help me with: 1. When I begin narrowing the DSP down, on filter 1 (2.7, std, offset -0.84) only the lower freq side moves. The DSP switches to the 2.1 filter, reacting the same, but when it narrows to about 1.10 (within filter 2; 2.1, offset 0.0) it changes so that both low and high move equally. Even narrowing continues through the 700 and 400 Hz filters. The reverse occurs in the same way. I have checked the offsets with the K3 program, and they are set as required. On the K-3 display the "bar-thing" always seems to move equally on both sides. Is this normal? 2. When seen on the P-3, on hi-cut-lo, if I move the lo side, the higher freq side moves, and if I move the hi side, the lower freq side moves. On the K-3 display the expected side moves. Again, is this normal? I have the last production software installed. This was first noticed when I got the P3 and a "big screen", when in a contest I wanted to shift the receiver up to avoid a disturbing signal and found I had to move the hi side to move the lo side! Now I am accustomed and just watch my screen to make sure I am moving outside of the interfering peak. These only "bother" me because I know there must be a reason but I don't why it happens! If curiosity is going to kill the "cat", don't tell me and I will just continue to be happy with my partial K-line! Thanks for your patience, Scott AA0AA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
