Thanks Bill this is exactly what I was looking for, some place to start. I was wondering if anyone else has setup any macros for mic selection. Thanks....
73 Jeff kb2m -----Original Message----- From: Bill Conkling [mailto:[email protected]] Sent: Wednesday, March 19, 2014 5:44 PM To: [email protected] Cc: [email protected] Subject: RE: [Elecraft] K3 macro's to switch mic's Jeff, I watched this nthread for a while and saw a dozen or so responses, but no-one bothered to help you with a macro or two. It seems that everyone has opinions on what mic or jack and maybe which fingefr to use to press the "ON". But, as for the macros, here goes. These are old, but you can see what I have done and adjust accordingly. Good luck! ************************************************ TO set mic to front for Hiel HM10-Dual Name: -MicFP Macro: MG020;CP020;MN053;DN;DN;TE-03-03+00+00+03+03+00+00;SWT11; ASSIGN TO PF1 This will set gain to 20, the compression to 20, set mic to front, adjust TX Equalization and set range to H To set rear for YAMAHA CM500 Name: -MicRPl Macro: MG017;CP005;MN053;DN;DN;UP;TE+00+00+00+03+03+03+03+03;SWT11; ASSIGN TO PF2 This will set gain to 17, compression to 5, set mic to rear, adjust TX Equalization and set range to L NOTE:' The setting for range H or L is a toggle. If you press the same function key twice, it will toggle the range. Therefore these macros leave the Main Menu active to show the Front/Rear and Range setting. Just press the MENY butoon and you are ready to go. If the range is wrong, just press keypad #1 to toggle to the other setting. ...bill -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Wednesday, March 19, 2014 12:06 PM To: [email protected] Subject: [Elecraft] K3 macro's to switch mic's Does anyone have (or know where I can get)a set of macros they would share with me that will change a K3's mic input, along with TX eq, mic gain, comp, etc. I'm setting my K3 up for the first time for other then DX use with the CM500 headset. I'm going to be also using an 8 pin Kenwood MC-50. My K3 was up to now for DX only use, but as I'm downsizing I would now like to it use for other types of operating, and would like to use macros for the first time to switch between the two mic's. Thanks in advance for any useful information... 73 Jeff KB2M ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
