Through N1MM and K3 software commands, I am able to send keying messages of
specific text from n1mm to the K3. In order to pass variables, such as the
other station and serial number, I need help to figure that out.
winkeyer command example to send cq from N1MM:
F1 RUN CQ,*cq {CQ MYCALL} {MYCALL} TEST*
K3 Command sent to K3 on com1 from N1MM:
F1 Run CQ,* {CATA1ASC ky cq na1dx na1dx test;}*
What I need to do is send the variable {TX} which is the station to work
WinKeyer Example:
F5 His Call,*{TX} ! de {MYCALL} {SENTRST} {EXCH} {EXCH} {MYCALL} TU k {RX}*
F5 His Call,* {CATA1ASC KY **{TX} ! **de {MYCALL} {SENTRST} {EXCH} {EXCH}
{MYCALL} TU k {RX};*
Is there a way you can escape from literal text to allow N1MM to pass text
from the variable {TX} and {EXCHANGE} as an example?
In my prior life doing programming with some weird languages, I remember
putting like an " or other special character to say don't use the following
text literally but capture the values out of a variable.
If you could, then you would not need a winkeyer or PSK/FSK/AFSK RTTY
sending device ever connected to the KX3/K3 for those modes.
You could use a sound card to assist in decoding or do like NaP3 does and
capture the output of the built in decoder.
73,
--
Doug Ellmore, Sr.
[email protected] / www.ellmore.net/na1dx
Amateur Radio Operator: NA1DX / P40DE
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
