Folks,
While attempting to do a K3 wattmeter calibration, I go into the CONFIG
menu. However, I only see "WMTR MW" and I cannot select any other power
settings, such as LP or HP. I ten checked to make sure the TECH MODE is on.
Going to that entry, I see "Funct ion" which I assume is On. However, I
cannot get this entry to turn off; when I rotate the main knob the setting
does not alternate between on and off...it always stays on.
1. How do I get into the wattmeter settings if tech mode is already on?
2. and how do I turn tech mode off after I am done with wattmeter
calibration?
Thanks for any hints.
--Ed--
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
