No luck. PA mode is already set to off.
On Tue, Apr 8, 2014 at 6:38 AM, Bob N3MNT <[email protected]> wrote: > The firmware update released after the KXPA100 was released, had an error > that in some cases turned PA MODE on even if there was no amp connected. > This automatically sets the KX3 ATU to not installed. Go into the the KX3 > menu to PA MODE if it is set to on, just change it to off and you will be > back to normal. > > > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/KX3-ATU-Disabled-Problem-tp7586823p7586833.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
