Hi All, have been having problems with PSK on my K3. I am using a
Microham2 Keyer into the K3 via the D connector and appropriate
connections on the K3.
I cannot TX though as I get no signal to the K3 output.
In Test mode with TX flashing on the K3 I see no indication of ALC
readings when I adjust the Mic knob when compression and ALC display is
shown.
When meter is in pwr mode `I see no indication of any power out either.
When in normal data TX mode (Not test) I have no indications of alc or
power showing on the bar graph either, but the K3 TX red light comes on
to indicate TXing. I have no replies to an calls and a colleague who was
testing with me did not RX anything from me at all.
I can RX fine.
All other modes work fine RTTY SSB and CW.
Any help gratefully received.
--
Regards from
Chris Soames
G0TZZ
email :-
[email protected]
www.norfolkamateurradio.org
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
