Phil,
Let me get this straight - the KPA500 is communicating with the K3, then
you switch to the KX3 and the KPA500 does not talk with the KX3.
If that is what is happening, I would expect that to be the case. The
communications with the K3 is not synchronized with the attempted
communications with the KX3, so a reset (power cycle) of the KPA500 may
be required.
73,
Don W3FPR
On 4/22/2014 7:02 PM, Phil Hystad wrote:
Some follow-up questions:
OK, I have the KX3 and K3 configured with the KPA500 and KAT500. Everything
seems to work with one little exception.
The exception:
--- initial conditions, K3 is on and switched to use the KPA500 and
KAT500. KX3 is off.
--- using K3 and so on works fine with amp on or with amp in standby.
--- I turn off K3. Leave KPA500 on but in STBY mode.
--- Switch coax from K3 to KX3 (1x2 switch).
--- Turn on KX3. KPA500 still in STBY mode.
--- Attempt to switch KPA500 to OPER from STBY but switch does not work.
If I power off the
KPA500 (front panel switch) and power back on then switch works fine.
I have experimented with all kinds of starting initial conditions and order of
events but whenever
the KPA500 is left on after using the K3 and then switching to the KX3, the
switch on the KPA500
to go from STBY to OPER does not work. I always have to cycle the power from
the front panel on/off
switch.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
