I am attempting to perform the opposite sideband and I.F.
image nulling procedure on my KX3, per the app note (rev
A8). I had no trouble performing the opposite-sideband
nulling steps, but have run into a problem in the I.F. image
(16 kHz) nulling procedure on page 5.
Step 7(a) on page 5 states that "you should hear a strong
signal". This contradicts step 14 on page 2, which states
"Note: If you are preparing to null the RX SHFT=8.0 I.F.
image, you may not hear any signal at this time since the
VFO is offset from the signal source by 16 kHz". In fact, I
am *not* hearing any signal.
Is it safe to assume that step 7(a) on page 5 is incorrect,
and that I can safely proceed without hearing any signal?
73,
Mark AI4BJ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
