I just had a thought: what about the rear mic jack (the 3.5mm) and the line out? Can that be done?
__________________ Slava (Sal) B, W2RMS [email protected] On May 10, 2014, at 1:29 PM, Bruce Beford <[email protected]> wrote: > With all due respect, you already received the answer here. Yes, you can > connect the Signal Link to the front panel mic connector. Just pad the audio > output of the SL to a mic level, instead of line level. Also, you won't be > able to get audio output from the K3 back to the SignalLink via that jack. > The RX audio of the K3 is not available there (see the manual). So you would > need another cable from line out on the back for that anyway. > > So... it would be easist to just patch it in via the back (via your rack of > signal shaping/mixing gear), as has been suggested. > Bruce > N1RX > > >> I knew this was going to turn into "why do you need all that audio gear" >> discussion. > >> Never mind. Thanks for your input. >> I guess i'll just ask Eric or Wayne next Friday at Dayton. > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
