I made a patch panel using adapters mounted on DIN rails from Winford Engineering.
73 Jim ab3cv On May 12, 2014, at 9:49 AM, W0MU Mike Fatchett <[email protected]> wrote: This is an issue. If you have a band decoder, want to run the preamp, the amp, tuner, and say a Microham device. I have used multiple Y adapters successfully. Mike W0MU > On 5/12/2014 6:04 AM, Don Wilhelm wrote: > Rich, > > I assume you also have a KPA500 in the mix. > The problem is not with adding another "Y" cable, but the possibility that > the other device will interfere with the band signalling to the KPA500. > If that other device has pullup resistors, that can create problems, > especially if the pullups are to some voltage other than 5 volts. You may > have to add isolating diodes to that device (the KPA500 does have those > protection diodes on the band data lines). > > If it has no pullup resistors, then it may be OK. > > 73, > Don W3FPR > >> On 5/12/2014 7:48 AM, Richard Thorne wrote: >> Currently I have a wye cable attached to the accessory jack on the back of >> my K3 which in turn is connected to a microham device and the KAT-500 tuner. >> >> I have a need to supply band data to another device, can I connect another >> wye to the current wye so I can connect 3 devices to the accessory jack? > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
