I have a doubt regarding the firmware of the SSB module of my first K2. I bought K2 S/N 1131 with the KNB2 and KSB2 modules. The kit was on the shelf of the shack for quite a long time. Finally and after knowing about the full update of the rig I decided to go for it and ordered the new set of boards and the A to B component kit together with a new set of matched crystals, new main CPU (2.03) and new I/O controller. The new K2 was serial number 3279. The question is as follows. I built the SSB board according to the last updated manual (not the original that came with the kit) including all the changes in the crystal filter (new capacitors and new matched crystals). If I am not wrong the firmware release on the original SSB board was 1.02. Although I operate almost 99% in CW I wonder if there is any issue regarding using the old SSB firmware with the updated CPU and I/O controller that I ordered with the upgrade from A to B. Frankly speaking I have not noticed anything strange when using the SSB module and the reports on the audio have been OK. I would appreciate your feedback regarding this matter.
Many thanks in advance for your replies and best 72 Vicenç, EA3ADV _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
