On 13/05/2014 04:59, Bill Turner wrote:
I then went through the power calibration procedure and it failed at 5
watts with the error message "Calibration failed because the transmit
power did not reach the expected level".
Bill,
I had this problem while building my K3 recently.
I spoke with the factory as it was fine when first tested.
It turned out that I had not tightened all the screws down when
refitting the PA. Once tightened down it came back to life. During my
conversation I was also told to check that the screws on the regulators
(bottom panel) are tight enough.
73 Clive G8POC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
