ORIGINAL MESSAGE: (may be snipped)
On 5/13/2014 12:19 AM, Clive Lorton wrote:
Bill,
I had this problem while building my K3 recently.
I spoke with the factory as it was fine when first tested.
It turned out that I had not tightened all the screws down when
refitting the PA. Once tightened down it came back to life. During my
conversation I was also told to check that the screws on the
regulators (bottom panel) are tight enough.
73 Clive G8POC
REPLY:
Thanks Clive, will do.
73, Bill W6WRT
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
