Hi Doug,
It's better to use the line in/out on the back of the K3 than the mic.
Also you will want to use Data A mode.
Once you have made that connection, what I use is Lin Out set at 1 and
the SLUSB set at noon (delay at zero).
Then adjust your audio DRIVERS (IN and OUT) in the software to max.
After that is done, adjust the Lin In (mic control in Data mode) to get
four full ALC LEDs showing with the fifth flickering) with transmit.
Then leave it alone.
Adjust your power output AFTER going through all that.
As has been stated numerous times, the K3 is not like any other radio in
this regard (and many others).
73,
Rick WA6NHC
On 5/13/2014 9:01 AM, Doug Ellmore wrote:
I set my Mic gain to 30-32 to get in the right range. I use an external
Signal Link which is set at 9'oclock for input and output.
73, NA1DX
Doug Ellmore
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
