Chuck,
WHAT! K2 SN 6951 was kitted much less than 10 years ago, and had
already been updated with ALL the Elecraft mods.
Also, what 2 meter option for the K2? The K2 does not have a 2 meter
option. If you want 2 meters, one must use the XV144 transceiver.
I hope you did not replicate mods that were already installed on the board!
OTOH, if you were updating a much earlier kit (original serial number
less than 3000) and you purchased the upgrade kit with new boards, then
all may be OK (those upgrades were issued a new serial number) - all you
needed to do is build the K2 using the newer manual.
73,
Don W3FPR
On 5/18/2014 9:35 AM, ke9uw wrote:
I took about 10 years to finish mine. I started it, put it aside and then saw
lots of mods and so forth, so I noted them and fit them into the
instructions. When I finally got back to it, I didn't have to unsolder
anything to fit the mods in. I did have to toss a firmware chip that had
never been installed in favor of a newer one that I ordered also.
It all worked when done! All the options installed but the 2M and the 100
watts.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
