While there isn't a specific control cable, the K3/10 does have the ability to set KXPA100 drive level per-band. Nearly all amplifiers have some gain variation from one band to the next, and this allows you to adjust drive for consistent power output. Refer to the PWR SET menu entry (CONFIG menu on the K3).
Wayne N6KR On May 21, 2014, at 7:53 AM, Don Wilhelm <[email protected]> wrote: > The KXPA100 can be driven from most any QRP rig, so the answer is definitely > 'Yes'. > Right now there is not a cable to fully integrate the K3 and the KXPA100, but > my guess is that there may be in the future. > In the meantime, the KXPA100 can be used in its RF sensing mode with most any > transceiver including the K3. > > 73, > Don W3FPR > > On 5/21/2014 9:51 AM, Joshua Gould wrote: >> Greetings, >> >> I have a silly question (I guess the silliest one is the one not asked, >> though...) I'm planning on starting with a KX3, and then adding in the >> KXPA100 and KXAT100 at a later date. If I already have the KXPA100 and >> KXAT100 and I decide to get a K3/10 later down the line, can I drive the >> KXPA100 from the K3? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
