Hi You can turn off the amp into a low power state and turn it on programmatically. The turn on is a bit tricky, and requires some delay and retries but it does work. However you cannot do the equivalent of turning off the power switch but that is really not needed. 73s Tom va2fsq.com
-------- Original message -------- From: Michael Walker <[email protected]> Date: 25/05/2014 16:37 (GMT-05:00) To: [email protected] Subject: [Elecraft] KPA500 question 2 - remote power control I have just installed my KPA500 on my remote base and I noticed that it is possible to turn it off via the computer or via just dropping the AC power and not getting it to come back on. This makes is sort of a challenge for remote operating. Is this normal operation or did I miss something obvious. 73 all Mike va3mw ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
